aeromax 10 Posted August 26, 2018 Report Share Posted August 26, 2018 After five years, HELLO to everyone Cheers Max Link to post Share on other sites
Captain Coffee 2,030 Posted August 26, 2018 Report Share Posted August 26, 2018 Welcome back. I can't imagine why anyone would be away from here for 5 years unless... Hope prison wasn't too hard on you mate! 2 Link to post Share on other sites
needles 1,013 Posted August 26, 2018 Report Share Posted August 26, 2018 Well Max, you've got a lot of reading and viewing to do. So, see you in five years when you may have caught up. Welcome back. Link to post Share on other sites
aeromax 10 Posted August 27, 2018 Author Report Share Posted August 27, 2018 9 hours ago, Captain Coffee said: Welcome back. I can't imagine why anyone would be away from here for 5 years unless... Hope prison wasn't too hard on you mate! THX. Big break due to a lot to do. New challenge / project gonna start. Link to post Share on other sites
aeromax 10 Posted August 27, 2018 Author Report Share Posted August 27, 2018 9 hours ago, needles said: Well Max, you've got a lot of reading and viewing to do. So, see you in five years when you may have caught up. Welcome back. THX. Indeed :-) Link to post Share on other sites
Bueckerpilot 0 Posted March 15, 2019 Report Share Posted March 15, 2019 Hallo Aeromax! I have a problem with my SIOC script for a TAT gauge. It is used as a compressor inlet temperature indicator with FSUIPC offset 11D0. It works fine from 0 to 125 Degrees (730kts IAS) , but below 0 degrees the servo is jumping to extreme values without any sense. The FSUIPC logging shows normal values below 0 Degrees. I have seen in other forums that there are sometimes problems with the FSUIPC TAT Offsets. Do you know something about that problems, or may i send you my script for a check? I use P3DV4 with FSUIPC 5 and SIOC 6.0B8. Ich sitze seit 2 Wochen an diesem Problem und komme da nicht weiter, bin aber auch kein LUA Experte! Grüße, Thilo Link to post Share on other sites
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now