Captain Coffee 2,030 Posted January 23, 2019 Report Share Posted January 23, 2019 (edited) I had a misshap with my yoke a couple month ago. My CH yoke broke internally, cracked at the clamp support tops where one of the desk clamp nuts are 'secured' within a molded plastic recess on top of a rather long plastic tube that accommodates the clamp screw shaft. Gosh how I hate plastic...but that's another story. My DIY sailor fix was to buy a drill press vice grip device and adapt it to be the new desk clamp. It required dremeling away the old plastic clamp support due to the much shorter new bolt, and adding a fat washer for extra support. It works WONDERFULLY, and is far easier to remove, and feels more secure than the other side/original desk clamp. I am tempted to buy another new clamp unit and replace the other side even though it isn't broken. This is how the original clamp is secured within the yoke, the nut is recessed into a plastic tube...the long clamp bolt protruding: The other side with the tube removed and the shorter Drill Press Clamp bolt secured in place over a large washer: Under table view of the new clamp in action...it has the same or slightly more "Knee Room" below it as the original clamp on the other side...and is far quicker to remove/replace, and feels more solid once snugged down: Pro-tip suggestion to Yoke and Controller makers...consider providing an easy (METAL FOR CRIPES SAKE) fast clamp system like this for future product upgrades. (edit to add: Pro-tip to ME: Consider dusting cat hair off of under table supports before taking photos...heh.) And a couple shots from my first flight after getting back into the cockpit finally with my newly secured yoke...phew. Cheers all. Matt/Capt. Coff. Edited January 23, 2019 by Captain Coffee 3 Link to post Share on other sites
UKJim 502 Posted January 24, 2019 Report Share Posted January 24, 2019 Looking good and nice you are back on board flying again. Don't worry about cat hair - it just shows you have got a life Too clean, means you have not lived 1 1 Link to post Share on other sites
needles 1,013 Posted January 24, 2019 Report Share Posted January 24, 2019 I just love anything that Heath Robinson would approve of. Very ingenious Matt and a great idea. Cheers Brian 1 Link to post Share on other sites
mutley 4,498 Posted January 24, 2019 Report Share Posted January 24, 2019 Very inventive Matt, great to see you in the skies again 1 Link to post Share on other sites
Captain Coffee 2,030 Posted January 26, 2019 Author Report Share Posted January 26, 2019 Thanks guys. It's great to be flying again. Link to post Share on other sites
dolf8857 640 Posted January 30, 2019 Report Share Posted January 30, 2019 Good to see you up there Matt, great shots! 1 Link to post Share on other sites
wain 879 Posted January 31, 2019 Report Share Posted January 31, 2019 nice fix Matt, sadly I would have lobbed it....no patience!! 1 Link to post Share on other sites
hlminx 301 Posted February 3, 2019 Report Share Posted February 3, 2019 The clamps on the saitek aren't much better either. A sound and innovative solution Coff 1 Link to post Share on other sites
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now