J G 927 Posted December 9, 2013 Report Share Posted December 9, 2013 I have just purchased the Just Flight DC3, and cant wait to get stuck into it. However I have an issue..... As you can see from the above I get a cutaway DC3! I have checked the JF support site and they do mention that you must have Service Pack 1 and 2 installed. I have MS FSX Acceleration installed that should have both in. If I try to install SP2 it tells me that it is already in place. Has any one had this issue before and solved it? I really want to fly this old lady! J. Link to post Share on other sites
mutley 4,495 Posted December 9, 2013 Report Share Posted December 9, 2013 Hi John, Take a back up of your FSX.cfg then delete it and let the sim build a new one to see if the problem lies there, you can then easily revert to your original FSX.cfg if that does not cure it. Joe Link to post Share on other sites
UKJim 502 Posted December 9, 2013 Report Share Posted December 9, 2013 Do you use EZDok? If so run the configurator tool again and then check again. Link to post Share on other sites
ddavid 149 Posted December 9, 2013 Report Share Posted December 9, 2013 That looks like the limited view of the exterior you get when you are in the VC mode and you move the eyepoint outside the airframe. You know, bits missing - I wouldn't be surprised if, when you went around to the starboard side, that part of the cabin exterior would disappear and you'd see 'inside' again. I'd uninstall and install again to see if that clears things up. Another thought, did you have your firewall going during install? This sometimes has funny repurcussions... Good Luck. Cheers - Dai. Link to post Share on other sites
J G 927 Posted December 9, 2013 Author Report Share Posted December 9, 2013 Thanks Joe and Jim. Jim's answer was the one that worked! I have just installed EZDok and am not up to speed with it's little ways yet! Link to post Share on other sites
mutley 4,495 Posted December 9, 2013 Report Share Posted December 9, 2013 Let's hear it for Jim! Thanks for the feedback John, it's good to know when suggestions work. Link to post Share on other sites
brett 2,303 Posted December 10, 2013 Report Share Posted December 10, 2013 @Jim- Link to post Share on other sites
UKJim 502 Posted December 10, 2013 Report Share Posted December 10, 2013 No problem - I am glad it worked for you. I had a similar issue with the A2A 172 but even after re-running the configurator several times it still did not fix it. I uninstalled both EZDok and 172 the re-installed - worked a treat blah. Cheers guys, Jim Link to post Share on other sites
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now